4gordi

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: VNCserver doesn't work #13677
    4gordi
    Participant

    I think i know, where my problem, if you connect to your RpI0 to ethernet and if you don’t connect to your wifi router, internal wifi module don’t wont go to monitor mode, but if you connect to your wifi ssid, problem is gone)

    root@pi-tail:~# mon0up
    ++ Bringing mon0 up
    ++ mon0 should be up:
    5: mon0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UNKNOWN mode DEFAULT group default qlen 1000
        link/ieee802.11/radiotap b8:27:eb:5c:28:59 brd ff:ff:ff:ff:ff:ff
    root@pi-tail:~#
    

    But i think it’s work wrong, maybe i’m unjust)

    in reply to: SSH into Pi-Tail problem #13670
    4gordi
    Participant

    Hey,Nigel) I seem i know,how to solve your problem. If you use the iphone as a hotspot for ssh communication with PI-kali, you need to change the /boot/interfaces and change the following lines:

    
    iface sepultura inet static
        address 172.20.10.9
        netmask 255.255.255.240
        gateway 172.20.10.1
    

    because iphone their ip address, before reboot raspberry and connect to your hot-spot) Enjoy!
    I’m use termius app for ssh connection, and realvnc app for vncserver, but before use vnc you should make port forwarding in termius, and activate port)How to make work with usb-hub – iphone and raspberry,i’m don’t know( Sorry for my english.

Viewing 2 posts - 1 through 2 (of 2 total)