gitxmax

Forum Replies Created

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • gitxmax
    Participant

    I tried creating mon0 with “iw phy phy0 interface add mon0 type monitor”, it does create it, without disabling wlan0, but somehow kills the wifi…

    in reply to: vnc problem #12531
    gitxmax
    Participant

    localhost no bit 🙂

    gitxmax
    Participant

    Actually, after running the sd card with fsck, fixed the kernel panic issue.
    I’ve been testing the terminal connection via GPIO pins, for a few hours now.
    Mostly, it’s working just fine.
    The only issue, I encountered so far, one of the scripts is shooting out “curses.error: curs_set() returned ERR” error, which seems to be connected with the terminal type.

    gitxmax
    Participant

    Tried using the serial, have to enable_uart=1 in config.txt, to activate it, otherwise nothing happens.
    Sadly, it crashes on start up, with kernel panic error.
    Any possible solution?

    gitxmax
    Participant

    Another thing, I want to try to implement, is to connect Pi Zero W to my android phone, via the ftdi device, for the console access, to spare the only usb port.

    gitxmax
    Participant

    Seems to work for me Today, not sure, what I was doing wrong before.
    Seems to be power sensitive, but finally works.

    Another thing, many pentensting tools are relying on network-manager to work properly and trying to set up interfaces, using it. Which, obviously, doesn’t work with Pi-Tail, out of the box.
    So, is it doable, to modify Pi-Tail, to be network-manager based, keeping all the current features active?

    in reply to: vnc problem #12518
    gitxmax
    Participant

    figured out..

    in reply to: A couple of issues #12500
    gitxmax
    Participant

    Thanks for your attention.

    Have changed nothing from the default, only replaced “home” in wpa_supplicant, to match my hotspot.

    Another test I made,
    Clean install of Pi-Tail.
    Removed pre-configured wpa_supplicant, interfaces files.
    Put my own interfaces file, containing only:

    auto wlan0
    allow-hotplug wlan0
    iface wlan0 inet dhcp
    wpa-ssid xxx
    wpa-psk xxxxx

    As I always do, on my clean installs, for simple configuration and connecting to wifi on first boot. This always works with re4son pre-build images.

    In this case, the connection to homework was successful, but, once again, no internet connection.

    Strangely, running setgw, return 10.42.0.145 as the default gw, where as my router is 10.42.0.1. I tried setting the default gw manually, to 10.42.0.1, which succeeded, but still, no internet connection established.

    Thanks again!

    P.S. Found the culprit.
    /etc/resolv.conf has 9.9.9.9 for nameserver, changing it to my router ip, fixed the issue.

    in reply to: A couple of issues #12461
    gitxmax
    Participant

    Just to add, setgw command had no effect..

Viewing 9 posts - 1 through 9 (of 9 total)