Re4son

Forum Replies Created

Viewing 5 posts - 701 through 705 (of 705 total)
  • Author
    Posts
  • in reply to: Comments from Blog Post “Sticky Finger’ Kali-Pi” #1052
    Re4son
    Keymaster

    Hi Stigh,

    About the “pip install RPi.GPIO” issue:

    Try running
    sudo apt-get install python-dev
    again. That should re-install the missing headers.

    About the “low priv user”:

    Not too sure what could have failed. Maybe one of the groups we created earlier is missing.
    You can check whether all groups have been created via the following command:
    grep ‘sudo|ftp|kismet’ /etc/group
    The output should be something like this:
    “sudo:x:27:pi
    kismet:x:116:pi
    ftp:x:1000:pi”

    Do you remember the command that triggered the error and what the message was?
    That’ll help me to pinpoint the culprit.
    Just post the result or shot me an e-mail and I’ll have a look at it.

    Hope that helps,
    Re4son
    Original author: Re4son

    in reply to: Comments from Blog Post “Sticky Finger’ Kali-Pi” #1051
    Re4son
    Keymaster

    Re4son,

    Thanks for a very well tutorial.
    Though I followed it step by step, I ended up with some “problems”;
    Under “Create a low privilege user”, the following commands didn’t work;
    # usermod -a -G sudo,ftp,kismet pi
    # /usr/bin/clear &
    # %pi ALL=(ALL:ALL) NOPASSWD: /sbin/poweroff, /sbin/reboot, /sbin/shutdown, /home/pi/pitftmenu/menu

    Under “Kali-Pi Launcher:”, the following commands didn’t work;
    # sudo pip install pbkdf2
    # sudo pip install RPi.GPIO

    I didnt get any further, hopefully you can assist on this; I would LOVE to have your menu running!
    Original author: Stigh

    in reply to: Comments from Blog Post “Sticky Finger’ Kali-Pi” #1050
    Re4son
    Keymaster

    This was THE most helpful source for my build, huge thanks homie.
    Original author: @ShreddieMurphy

    in reply to: Comments from Blog Post “Sticky Finger’ Kali-Pi” #1049
    Re4son
    Keymaster

    Hi Tranquillechat,

    works just as well with the 2.8″
    You only have to adjust the dimensions of the menu.

    Cheers,
    Re4son
    Original author: Re4son

    in reply to: Comments from Blog Post “Sticky Finger’ Kali-Pi” #1048
    Re4son
    Keymaster

    hi,
    I m very interested in this tuto/project.
    I’m about to buy a tft screen “adafruit” but the 3.5″ cost more for europe.
    Do you think this is work well with a 2.8″ ?

    Thanks par avance,
    regards
    Original author: tranquillechat

Viewing 5 posts - 701 through 705 (of 705 total)